Friday, February 18, 2022

Time: 2h

• Researched SDS Ignition, SureFly, ElectroAir and E-mags for an ignition source. Decided on E-mags P model and ordered. ETA March 18th.
• Cut, Fit, Cleaned up lower side right and left stringers

Photo Stream

Notching out the front of the lower right side stringer

Cutting the rear off the lower side left stringer

Front lower left stringer fit

Left lower rear stringer fit

Lower stringers fit

They are not yet attached. Just fit and clamped into place right now. I'll wait until I have all stringers fit, then attach.

Right front lower stringer fit

Note, the left and right front lower fits were slightly different. I did the left first then used it as a template, and that didn't work. Luckily there is a lot extra on these stringers, so I had plenty left to cut off the front area I notched out and do it again.

Lower left rear stringer fit